![]() Now without actually owning a NSA-310 yet I can't test this new firmware. ![]() Once logged in with the FTP username/password supplied, I can also see a number of packages in: Here is the link to the firmware in question. So it appears that v4.4 is on some kind of "trial/prerelease release" at the moment, and I haven't seen much feedback about the new firmware. I've been following this thread about the v4.4 release schedule, and came across a post on the zyxel forum. so managed to get this for £30 (diskless) today - will need to wait a few days for it to arriveĪnyway back to the point. The previous squeezebox2.version file hadīeen looking at the NSA-310 as a cheap solution for my SB server (so that I have a box that is always on). The squeezebox2.version file states what versions are be upgraded, here is a copy of the contents # future versions may be downgraded to this one The receiver.version file states what versions are be upgraded, here is a copy of the contents Zyxel firmware update windows#I used a windows laptop and installed 7.6 of squeezebox to get the following receiver firmware files for copying to my NAS i-data/md0/.zyxel/zy-pkgs/gui/SqueezeCenter/Firmware You can now telnet to your NAS, use root + the admin passwordĪll the firmware for the squeezebox devices are stored in Turn on the telnet backdoor by going to the following URL I am running version 7.5.1 on my NSA-310 and am running upgraded versions of firmware on my duet controller and receiver taken from newer versions of squeezebox, here is how i did it. Increasing this number should work but has not been tested.Version 1 (just in case it needs updating Note that the number at the end indicates the size to write in hex. NSA310>nand write 0x2000000 ubi $filesize NAND erase.part: device 0 offset 0x140000, size 0x7ec0000 Use USB retry period from the environment: 15 second(s) One for the U-Boot and one for the OpenWrt firmware NSA310>usb reset There could be the need to use two different USB Sticks. Then we proceed to flashing OpenWrt itself (which we called nsa310.bin for less typing): NSA310>setenv bootcmd 'run setenv bootargs ubi part ubi ubi read 0x800000 kernel bootm 0x800000' Now we set the correct environment variables Zyxel firmware update mac#NAND write: device 0 offset 0x0, size 0x100000Īfter the device reboots into the OpenWrt u-boot we adjust the device's MAC address (adjust the values, see the sticker under the NAS case):Īddress in environment is AB:CD:EF:00:11:11 NAND erase: device 0 offset 0x0, size 0x100000 Disconnect power from nsa310, press power button for 5 seconds (to make sure everything is discharged and power is off) You may need to try a few times, and from true power off state.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |